Table of Contents
Advertisement
Assembly
1.
Attach the handle (A, Figure 1) to the frame
using two hex cap bolts, two lock washers,
and two flat washers. Tighten with a 19mm
wrench.
Note: The two rear casters can be locked so
that they do not rotate. Press foot lever (B,
Figure 1)
2.
Attach foot lever (A, Figure 2) to the lever
bracket (B, Figure 2) with one hex cap screw,
one flat washer, and one lock washer (C,
Figure 2). Tighten with a 14mm wrench.
Keep hands and feet clear of
table
and
scissor
lowering load. Failure to comply may cause
serious injury!
3.
Pump the foot lever several cycles so that the
table is out of your way while attaching the
cable.
Note: Place a 2" x 4" board straight up and
down between the table and frame so that the
table cannot come down on you while
attaching the cable.
4.
Route the cable (A, Figure 3) into the cable nut
(B, Figure 3). Run the cable through the
lowering mechanism (C, Figure 3) and pull the
cable tight. Tighten the hex nut (D, Figure 3)
using a 14mm wrench.
Note: You may have to turn the socket head
cap screw to line up the hole. This will allow
the cable to pass through freely.
Operation
1.
The table can be raised by pumping the foot
lever.
2.
To lower the table, pull the release lever fully.
This allows the table to lower in a slow,
controlled manner.
3.
Before loading, lock both caster brakes.
4.
Center and secure load on table.
5.
Before moving load, lower table fully and
unlock caster brakes.
lift
openings
while
Figure 1
Figure 2
Figure 3
5
Advertisement
Table of Contents
