Advertisement
OPERATOR'S MANUAL
:
BRANCHES
Vancouver
Edmonton
3260 Production Way
4120 - 78 Avenue NW
Burnaby, B.C.
Edmonton, Alberta
V5A 4W4
T6B 3M8
Tel:(604) 444-5300
Toll free:
Toll free:1-800-472-7685
Tel: 1-800-468-1628
Fax:(604) 444-9227
Fax: 1-800-663-7742
L90 MODEL CHAIN HOISTS
½TON THROUGH 10 TON
Winnipeg
951 Powell Avenue
Winnipeg, Manitoba
R3H 0H4
Tel:(204) 632-6970
Toll free:1-800-665-7524
Fax:(204) 694-9534
www.jetequipment.com
Toronto
Montreal
416 Watline Avenue
4620 rue Garand
Mississauga, Ontario
St-Laurent, Quebec
L4Z 1X2
H4R 2A2
Tel:(905) 502-8665
Sans frais:
Toll free:1-800-387-3879
Tel:1-800-363-2885
Fax:(905) 502-7707
Fax:1-800-267-3310
Halifax
#123-11 Morris Drive
Dartmouth, Nova Scotia
B3B 1M2
Tel:(902) 468-8324
Toll free:1-800-472-7686
Fax:(902) 468-3461
Advertisement
Related Manuals for Jet L90
Summary of Contents for Jet L90
- Page 1 OPERATOR'S MANUAL L90 MODEL CHAIN HOISTS ½TON THROUGH 10 TON BRANCHES Vancouver Edmonton Winnipeg Toronto Montreal Halifax 3260 Production Way 4120 - 78 Avenue NW 951 Powell Avenue 416 Watline Avenue 4620 rue Garand #123-11 Morris Drive Burnaby, B.C. Edmonton, Alberta...
-
Page 2: Table Of Contents
ONE YEAR LIMITED WARRANTY JET™ Manual Hoists are guaranteed to be free of defects in material and workmanship. If one of these products fails during the first year of operation due to defective material or workmanship it will be repaired or replaced at our discretion. Normal wear and tear on moving parts is excluded from this guarantee. -
Page 3: Prior To Installation
PRIOR TO INSTALLATION Check for damage during shipment. Place claim with carrier if any damage is discovered. DO NOT install or use a damaged hand chain hoist. Check and verify that structure or other equipment that will support the hand chain hoist has a rated load capacity equal to or greater than the rated load capacity of the hand chain hoist to be used. -
Page 4: Inspection And Maintenance
INSPECTION AND MAINTENANCE Prior to initial use, all new, modified, and repaired hoists shall be inspected in accordance with Table 2. Thereafter, inspections shall be conducted at intervals shown in Table 1; and items to be inspected are indicated in Table 2 by F (Frequent) or P (Periodic). -
Page 5: Hooks
HOOKS WARNING 1. Any hook that requires replacement because of excessive bends, twists, or throat opening indicates abuse or overloading of the hoist. Therefore, other load-supporting components of the hoist should be inspected for possible damage when such conditions are found. 2. -
Page 6: Chain
CHAIN Inspect chain at least once a month. Between regular inspections, check visually daily for nicks, gouges, weld splatter, corrosion, or distorted links. Inspect chain thoroughly if it does not feed smoothly over load sheaves. Inspect as follows: 1. Clean chain with solvent before inspection. 2. - Page 8 L-90 1/2 TON - 5 TON MODEL ITEM# DESCRIPTION TOP HOOK ASSY GEAR SIDE PLATE ASSY WHEEL SIDE PLATE ASSY LOAD SHEAVE ASSY BOTTOM HOOK ASSY SAFETY LATCH ASSY (OLD STYLE) SAFETY LATCH ASSY (NEW STYLE) GEAR CASE ASSY 2ND & 3RD GEAR ASSY STRIPPER ASSY TOP HOOK PIN STAY BOLT...
- Page 9 L-90 10 TON MODEL ITEM# DESCRIPTION TOP HOOK ASSY GEAR SIDE PLATE ASSY WHEEL SIDE PLATE ASSY LOAD SHEAVE ASSY BOTTOM HOOK ASSY SAFETY LATCH ASSY GEAR CASE ASSY 2ND & 3RD GEAR ASSY STRIPPER ASSY TOP HOOK PIN STAY BOLT COVER NUT WASHER HAND WHEEL COVER...