Installing The Lock - Kaba 7102 series Installation Instructions Manual

Installing the Lock

7
3 3
• For 1 ⁄ " - 1 ⁄
8 4
3
use the 2 ⁄ " (44 mm) thru bolts.
8
1
• For 2" - 2 ⁄ " (51 mm - 57 mm) thick doors,
4
use the 3" (76 mm) thru bolts.
1) With the bolt extended in the locked
position, mount the lock from the outside
of the door. Insert the tailpiece Y into the
vertical cutout of the bolt assembly and
the tailpiece X into the
figure 7-1.
2) Hold the exterior lock assembly firmly
against the door. Try the factory-set
combination. Press buttons #2 and #4
together, release, press button #3, and
release. A distinctive click must be felt to
indicate that the button has been correctly
depressed. Turn the outside thumbturn to
the right (clockwise) to the stop position
and release (the bolt should be fully retrac-
ted). If not, turn the thumbturn to the left
(counterclockwise) to the stop position
and repeat Step 2.
3) While holding the lock firmly against
the outside surface of the door with one
hand, use the other to mount the inside
thumbturn assembly to the interior side of
the door with two thru-bolts finger tight,
figure 7-2. Make sure that tailpiece Y
is engaged into the vertical cutout of the
inside thumbturn assembly.
4) Insert tailpiece X into the horizontal slot of
the combination change assembly, It may be
necessary to use a screwdriver to align tailpiece
X with the combination change assembly,
figures 7-2 & 7-3. Once aligned, secure with
two thru-bolts, but do not tighten, figure 7-4.
" (35 mm - 44 mm) thick doors,
3
⁄ " (19 mm) hole,
4
7-1.
X
Y
9