Customer Level Access; Customer Level Access Using The Prog Key - Samsung iDCS 100 User Instructions

HOME PAGE Table of Contents
SYSTEM ADMINISTRATOR
PROGRAMMING

CUSTOMER LEVEL ACCESS

Before any customer programs can be accessed, you must first open sys-
tem programming using the passcode you have been assigned. You must
use a display keyset. Should it become necessary to change this passcode,
see your service company.
• While on-hook, press TRSF and then dial 200.
Your display shows [ENABLE CUS. PROG. PASSCODE].
• Dial the four digit passcode.
The display shows [ENABLE CUS. PROG. - DISABLE].
• Dial 1 to enable.
The display shows [ENABLE CUS. PROG - ENABLE].
• Press TRSF. The keyset returns to its idle condition.
• Press TRSF and then dial the three digit program code you want to
access. Follow the instructions for that program.
NOTE: You must begin programming within 30 seconds. Once you are in
programming, any delay of more than 30 seconds between key strokes will
cause the system to automatically close programming.
CUSTOMER LEVEL ACCESS USING
THE PROG KEY
A designated keyset may be programmed with a "PROG" key which allows
access to the following areas of system programming. When pressed you
must enter your station passcode (the default code 1234 must be changed)
followed by the MMC number. The only MMCs that may be entered from
pressing the "PROG" key are as follows:
• MMC 100 Station Lock for All Stations
• MMC 102 Station Forward for All Stations
• MMC 104 Station Name
• MMC 115 Program Message for all Stations
• MMC 505 System Day and Time
• MMC 705 System Speed Dial
• MMC 706 System Speed Dial Name
Guide-Contents
10