Table of Contents
Advertisement
RCN Configuration Table for All WSHP Units
= WSHP Configuration
D4
Function Selection
Flash
Table 1 - Control Mode
Count
WSHP
1
Heat Pump
Table 2 - Short Cycle
Short Cycle - Active
2
Short Cycle - Inactive
Table 3 - Fan Speed
Fan Speed 1 Only
Fan Speeds 1 and 2 Enabled
3
Fan Speeds 1, 2 & 3 Enabled
Hi/Low Fan Speed Operation
IM 1119-1
D3
Flash
Count
Fan will speed-hunt in AUTO. Fan speed 1, 2, or 3 may be manually selected to run continuously at that
1
selected speed.
Fan will speed-hunt in Auto. Fan speed 1, 2 or 3 may be manually selected to run continuously at that
3
selected speed. Only control mode where O/B terminal will ever be energized
The "Y" terminal/control line output signal is delayed by 3-minutes after a compressor run cycle or upon unit
1
power-up
The "Y" terminal/control line output signal is allowed to energize immediately after a compressor run cycle or
2
upon unit power-up .
1
Fan will speed-hunt in AUTO. Fan speed 1 or 2 may be selected to run continuously.
2
Fan will speed-hunt in AUTO. Fan speed 1, 2 or 3 may be selected to run continuously.
3
Fan speed 1, 2 or 3 may be manually selected to run, continuously at that speed.
4
Fan speed 1 = Low, Fan speed 2 = High
Description
13
.
www.DaikinApplied.com
Advertisement
Table of Contents
