P5 Power Monitoring Setting; Exit P Parameter Setting - SZKTDZ KT-LCD6 User Manual

button (UP) or
the same to that of P2.
○

P5 Power Monitoring Setting

Enter P5 parameter setting interface after P4 parameter setting is finished, P5
parameter column flashes.
P5 is power monitoring setting, when P5 setting is 0, the power monitoring is the
"real-time voltage" mode. Namely, it is the method to determine the battery capacity
based on real-time battery voltage. When P5 equals to a specified parameter, the power
monitoring is the "smart power" mode (this parameter is determined by the battery
characteristics, ordinary 24V lithium is generally is 4-11, 36V lithium is between 5_15). P5
setting ranges from 0-40, hold
selection. P 5 parameter setting method is the same to that of P2.
After finishing P5 parameter setting, hold
set the values, and then P5 parameter column stops flashing. Hold
shortly again, the meter re-enter P1 parameter setting interface. Or hold
long for about 2 seconds to exit P parameter setting environment and return to the display
1.
○

Exit P Parameter Setting

Among the five P parameter settings, when each parameter setting is completed, if
ELECTRIC BICYCLE METER KT—LCD6 Product User Manual
button (DOWN) shortly for selection. P4 parameter setting method is
P5 parameter setting interface
button (UP) or button (DOWN) shortly for
button (SW) shortly to save current
- 24 -
button (SW)
button (SW)