Exit C Parameter Setting; Parameter Copy - SZKTDZ KT-LCD6 User Manual

C14 is the parameters of power-assist tuning setting, with the default value of 2. The
power-assist is between1-4 gear, and it is invalid until P3 equals to 1. The setting range 1-3,
and press (UP) button or
C14 parameter definition table:
C14 Value
After finishing C14 parameter setting, hold
set values and enter C1 parameter setting interface again. Or hold
for about 2 seconds to exit C parameter setting environment and return to the display 1.
○

Exit C Parameter Setting

Among the fourteen C parameter settings, when each parameter setting is completed,
if held button (SW) long for about 2 seconds, all can exit the setting environment
and return to display 1, meanwhile, the current set parameters would be saved.
Under each parameter setting interface, if there's no button operation on the meter for
more than 1 minute, and then the meter will automatically return to display 1, and the
original set parameters will be saved.

Parameter Copy

Set parameters (include general project parameter, P parameter and C parameter) of
all KT-LCD6 meter produced by our company according to requirements, and set the meter
ELECTRIC BICYCLE METER KT—LCD6 Product User Manual
C14 parameter setting interface
(DOWN) button for short to make selection.
1
2
3
Assist strength of intelligent pedal motor
Weak assist strength of motor
General assist strength of motor
Stronger assist strength of motor
button (SW) shortly to save current
- 40 -
button (SW) long