Table of Contents
Advertisement
faqs
Q:
Which wire is the "hot" wire versus the "load" wire?
A:
To determine this safely, begin by confirming that power is off to the
device location at the circuit breaker. Cap all of the exposed wires in the
electrical box, then turn the power back on at the device location. Find your
non-contact voltage tester. Place your voltage tester next to each of the
wires. The voltage tester should indicate which of the two wires is receiving
power from the circuit box (refer to the voltage tester's user manual for
details on operation). The "hot" wire is the powered wire.
To safely complete your wiring, turn off power at the circuit breaker until the
device is secured into the wall.
23
Hide quick links:
Advertisement
Table of Contents
