Safety Information - vacuubrand BVC Basic Manual

Safety information!

IMPORTANT
NOTICE
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. 11/08/2015 // 999281
In case of devices which have been in contact in contact with biological substances
of risk level 2 contact the VACUUBRAND service absolutely before shipping the
device. These devices have to be completely disassembled and decontaminated by
the user prior to shipment.
Do not return devices which have been in contact with biological substances
of risk level 3 or 4. These devices cannot be checked, maintained or repaired. The
devices must not returned to VACUUBRAND due to a residual risk in spite of decon-
tamination.
The same conditions apply to on-site work.
This manual describes the decontamination of the aspiration systems BVC and the
handle VHC .
pro
The applicability of the decontamination method and the selection of the ap-
propriate disinfectants have to be ensured by the user.
Ensure that work is done only by an appropriately trained and supervised personal.
Obey local and national safety requirements. Ensure that the personal is familiar
with the safety procedures which relate to the products processed by the pumping
system. Ensure that the device is decontaminated before repair and that you take
adequate precautions to protect people from the effects of hazardous substances if
contamination has occurred.
+ Take adequate precautions to protect people from the effects of dangerous sub-
stances. Wear appropriate personal protective equipment (e. g., protective clothing,
safety glasses, protective gloves) and perform work in a hood.
Prior to decontamination isolate equipment from mains. Allow sufficient cooling.
Ensure that the device cannot be operated accidentally.
Wait 5 seconds before starting work to allow the capacitors to discharge.
Before starting check that the required parts (e. g. tools, disinfectants) are available
and of the correct type.
Check the operating sequence mentally on feasibility, safety requirements and con-
sequences on safety and function of the equipment.
Obey regulations when disposing of solvents and chemicals.
In order to comply with law (occupational, health and safety regulations, safety at
work law and regulations for environmental protection) vacuum pumps, components
and measuring instruments returned to the manufacturer can be repaired only when
certain procedures (see section "Repair - Maintenance - Return - Calibration")
are followed.
Scrapping and waste disposal
Dispose of the pump and any components removed from it safely in accordance with
all local and national safety and environmental requirements.
page 5 of 20