Testing The Configuration Of Fastrack - Wavecom Fastrack M1200 series User Manual

4 Testing the configuration of Fastrack

Following table contains AT commands. Use these commands to perform initial tests of the modem
configuration.
Task AT commands
Enter PIN Code AT+CPIN=1234
Module synchro AT+CREG ?
checking
Receiving an ATA
incoming call
ATD1234;
Initiate a call
Initiate an ATD112;
emergency call
Communication
loss
Hang up ATH
Store the AT&W
parameters in
E2P
confidential ©
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged without prior written
agreement.
Ce document est la propriété exclusive de WAVECOM. Il ne peut être communiqué ou divulgué à des tiers sans son
autorisation préalable.
Table 13: Testing Fastrack configuration
Module
OK
+CME ERROR: 16
+CME ERROR: 3
CREG=<mode>, 1
CREG=<mode>, 2
CREG=<mode>, 0
RING
OK
OK
CME ERROR: 11
CME ERROR: 3
OK
NO CARRIER
OK
OK
WM_MKT_Fastrack_UGD_001 - 002
September 2002
Comments
PIN Code accepted
Incorrect PIN Code
(with +CMEE = 1 mode)
PIN already entered
(with +CMEE = 1 mode)
Modem synchronized on the
network
Synchronization lost,
resynchronization attempt
Modem not synchronized on the
network, no synchronization attempt
Answer the call
Do not forget the « ; » at the end for
voice calls
Communication established
PIN code not entered (with + CMEE
= 1 mode)
AOC credit exceeded or a
communication is already
established
Do not forget the « ; » at the end for
voice calls
Configuration settings are stored in
E2P
Page : 15 / 29