Table of Contents
Advertisement
Adding Units to the Stack
This section describes how to add one or more units to the
middle of a stack or to the end of a stack.
Note:
10/100/1000 Series Switch for information about
installing units on a tabletop or in a standard
19-inch utility rack.
Adding Units to the Middle of a Stack
To add one or more units to the middle of a stack,
complete the following steps:
1.
Determine the position of the new units in the
existing stack
For example, the shaded units (units 5 and 6) in
Figure 12
stack. The new units are numbered as unit 5 and unit 6
because they are additions to an existing 4 unit stack.
2.
Disconnect the cascade cable from the Cascade A
In connector at unit 3.
Leave the other end of the cascade cable connected to
the Cascade A Out connector at unit 2.
3.
For 19-inch rack configurations, move the units
two spaces lower in the rack.
Refer to Using the BayStack 450
(Figure
show two new units to be added to the
12).
28
Advertisement
Table of Contents
