Assigning a New Base Unit to the Stack
To assign a new base unit to the stack, complete the
following steps:
Note:
always configure the top unit in the stack as the
base unit.
1.
Set the Unit Select switch on the original base unit
to the Off position.
See
Figure 9
Select switch.
2.
Set the Unit Select switch on the new base unit to
the Base position.
3.
Renumber the Stack.
See the Using the BayStack 450 10/100/1000 Series
Switch guide for detailed information on how to
renumber the stack configuration.
Bay Networks recommends that you
on
page 20
27
for details about the Unit