Advertisement
26. Locate the supplied (2) 6mm x 15mm bolts, (2) 6mm
flat washers and the original (2) nuts that secured the ECU
to the ECU bracket. Next using a 10mm socket, 3"
extension, ratchet and 10mm wrench attach the ECU to
the relocation bracket as shown. (Bolt head and washer on
the bracket side, nuts on the ECU side)
27. Next install the (2) AOS coolant lines onto the AOS
(Lines come pre-assembled). **The short line of the two
attaches to the bottom of the AOS. Thread them on by
hand and tighten using ⅞" open end wrench.
28. Install the bracket onto the AOS using the (3) small
allen bolts as shown. The third hole from the bottom of
the AOS should be oriented to the lowest allen bolt hole
on the bracket. Tighten the three allens.
*Note in April 2016 the mounting bracket for the AOS
was changed. This affected routing of the wiring harness.
Some pictures after "Step 34" may show the older
mounting solution. The older images will not affect the
install of AOS's with the most current mounting bracket.
29. Locate the Competition Series upper breather fitting
and O-ring. Fit the O-ring onto the fitting as shown. Then
insert the fitting on the top of the AOS.
IAG Performance | 1203 Baltimore Blvd. Westminster, MD 21157 | Ph: 410-840-3555 | www.iagperformance.com
21
Advertisement
