Table of Contents
Advertisement
BATTERIES
The Taker B30 uses three (3) or six (6) CR123 batteries. As long as there
are at least three (3) installed, (either on the left or right side), the light will
function.
Using three (3) CR123 batteries decreases the battery life by half, but
does not effect the light intensity .
Mixing of new and used, or different brand batteries is not recommended
as this could lead to leakage or explosion.
BATTERY INSTALLATION AND REPLACEMENT
1
BATTERY
COMPARTMENT
COVER
1.
1
Open all four (4) of the Battery Compartment Tabs.
Insert six (6) CR123 batteries. Reference the plus ( + ) and minus ( - ) symbols
2.
2
located on the inside of the Battery Compartment for proper installation.
REASSEMBLING THE BATTERY COMPARTMENT
1.
Once batteries are installed, test the light's performance by activating the
1
Power/Mode Switch located on the top of the light.
2.
Secure the Battery Compartment Cover by snapping all four (4) Battery
2
Compartment Tabs. A 'click' should be heard as the snaps are shut.
NOTE: Make sure the Battery Compartment is properly closed to
maintain a water tight seal.
2
5
Advertisement
Table of Contents
