Download  Print this page

Cleaning The Pre-filter - Philips AC1214 User Manual

Hide thumbs

Advertisement

Note
• If the air purifier is used in a dusty
environment, it may need to be
cleaned more often.
• If the humidity level in the room is
very high, condensation may develop
on the air quality sensor and the air
quality light may indicate a more poor
air quality even though the air quality
is actually good. If this occurs, clean
the air quality sensor or use the air
purifier on a manual speed setting.
1
Switch off the air purifier and
unplug from the power socket.
2
Clean the air quality sensor inlet
and outlet with a soft brush (fig. q).
3
Open the air quality sensor cover
(fig. r).
4
Clean the air quality sensor, the
dust inlet and the dust outlet with a
damp cotton swab (fig. s).
5
Dry all parts thoroughly with a dry
cotton swab.
6
Reattach the air quality sensor
cover (fig. t).
Note
• Always keep air quality cover closed
while the air purifier is working.

Cleaning the pre-filter

Clean the pre-filter when F0 is displayed
on the screen (fig. u).
1
Switch off the air purifier and
unplug from the power socket.
2
Pull the bottom part of the front
panel and then gently lift to remove
it from the air purifier (fig. c).
10
EN
3
Press the clip down (1) and pull the
pre-filter towards you (2) (fig. d).
4
If the pre-filter is very dirty, use a soft
brush to brush away the dust. Then
wash the pre-filter under running
tap water (fig. v).
5
Allow the pre-filter to air dry
thoroughly before placing back in
the air purifier.
Note
• To optimize the lifetime of the pre-
filter, make sure it dries completely
after cleaning.
• Wash your hands after handling the
filter.
6
Put the pre-filter back into the air
purifier (fig. h).
Note
• Make sure the side with the clip is
pointing towards you, and that all
hooks of the pre-filter are properly
attached to the air purifier.
7
To reattach the front panel, press
the top part of the panel onto the
top of the air purifier (1). Then, gently
push the panel against the body of
the air purifier (2) (fig. i).
8
Put the plug of the air purifier in the
power socket.
9
Touch and hold the
3 seconds to reset the pre-filter
cleaning time (fig. w).
10
Wash your hands thoroughly after
installing filters.
for

Advertisement

Table of Contents

   Also See for Philips AC1214

Comments to this Manuals

Symbols: 0
Latest comments: