Planet VC-231GP User Manual page 18

Refer to the following procedure to set up the VC-231GP to IP
DSLAM connection.
1. [Remote End] Set the remote IP DSLAM/VDSL2 switch to
CO mode with proper VDSL2 profile.
2. [Local End] Set the VC-231GP at the local end to CPE mode
from the DIP switch.
3. Power on the VC-231GP CPEs by connecting its power source.
4. Power LED will illuminate.
5. Connect VDSL line from IP DSLAM/VDSL2 switch to RJ11
VDSL port of the VC-231GP.
6. VDSL LNK LED will blink to illuminate.
7. Connect telephone to the RJ11 Phone port of the VC-231GP.
8. Connect the VC-231GP Ethernet LAN port to other network
device via regular Cat.5 UTP cable.
When deciding where to put the converter and/or prolong the
operational life of the bridge, please also refer to the following
points:
It is accessible and cables can be connected easily.
„ Cabling is away from sources of electrical noise such as
radios, transmitters, motors, power lines and fluorescent
lighting fixtures.
„ Do not place objects on top of any unit or stack.
„ Water or moisture cannot enter the VDSL2 Bridge.
„ Air flowing around the unit and through the vents on the side
of the case is not restricted (We recommend that you provide
a minimum of 25mm clearance.).
18