Chapter 5: Wireless Tab; Basic Wireless Settings - Ubiquiti AirFiber 11FX User Manual

airFiber AF-11FX User Guide

Chapter 5: Wireless Tab

The Wireless tab contains options to set up the wireless
part of the link. This includes wireless mode, link name,
frequencies, output power, speed, wireless security, and
advanced wireless settings.
Test Changes To try the changes without saving them,
click Test Changes. A new message appears. You have two
options:
Apply To immediately save your changes, click Apply.
•
• Discard To cancel your changes, click Discard. If you
do not click Apply within 180 seconds (the countdown
is displayed), the AF‑11FX radio resumes its earlier
configuration.
Revert Changes
To cancel your changes, click
Revert Changes.
Save Changes To save your changes, click Save Changes.
Write down the settings you configure on the Wireless tab.
You will need to enter the same settings on the AF‑11FX
radio at the other end of your PtP link. The exceptions are
as follows:
• Wireless Mode Configure one AF‑11FX radio as the
Master and the other as the Slave.
• TX Frequency, RX Frequency
RX Frequency on one AF‑11FX radio are configured as
the RX Frequency and TX Frequency, respectively, on the
other radio.
Ubiquiti Networks, Inc.
The TX Frequency and

Basic Wireless Settings

In this section, configure the basic wireless settings, such
as wireless mode, link name, country code, frequencies,
output power, speed, and gain.
Wireless Mode
By default, the Wireless Mode is Slave. You
must configure one airFiber X radio as Master because
each PtP link must have one Master.
Link Name Enter a name for your PtP link. This name
must be the same on both Master and Slave radios in
order for them to connect.
Country Code This is preset to Licensed and cannot be
changed.
Channel Bandwidth Select the appropriate channel size:
3.5, 5, 7, 10, 14, 20, 28, 30, 40, 50, or 56 MHz.
Note:. The available channel bandwidths depend
on the regulatory requirements of the currently
selected country or region.
Radio Mode Use this setting to configure the mode of
the radio to MIMO or SISO.
Chapter 5: Wireless Tab
21