airFiber AF-24/AF-24HD User Guide
Chapter 5: Wireless Tab
The Wireless tab contains everything needed to set up
the wireless part of the link. This includes wireless mode,
link name, frequencies, output power, speed, gain, and
wireless security.
Write down the settings you configure on the Wireless tab.
You will need to enter the same settings on the airFiber
AF-24 at the other end of your PtP link. The exceptions are
as follows:
•
Wireless Mode
Configure one airFiber AF-24 as the
Master and the other as the Slave.
•
TX and RX Frequencies
Master should be used as the RX Frequency on the Slave,
and vice versa.
For Half Duplex mode (default), the TX and RX Frequencies
can be the same or different frequencies, in response to
local interference.
RX
TX
Master
Half-Duplex Diagram
Ubiquiti Networks, Inc.
The TX Frequency on the
RX
TX
Slave
For Full Duplex mode, the TX and RX Frequencies should be
different.
RX
TX
Master
Full-Duplex Diagram
Basic Wireless Settings
In this section, configure the basic wireless settings, such
as wireless mode, link name, country code, duplex, duty
cycle, output power, modulation rate, gain, and rate
adaptation.
Wireless Mode
By default, the Wireless Mode is Slave. You
must configure one airFiber AF-24 to Master because each
PtP link must have one Master.
Link Name
Enter a name for your PtP link.
Chapter 5: Wireless Tab
RX
TX
Slave
29