Table of Contents
Advertisement
02-Operating
3/2/00 9:36 AM
Page 11
3. Before starting your print job, make sure that you select the correct
paper size and feed source in your application. See 'Print settings' on
page 2.13.
4. Send the data to the printer from the application. When all the data is
transmitted, the PAPER light blinks.
5. Press the button on the control panel. Printing starts.
6. If you have more than one page to print, when the PAPER light blinks,
load next sheet and press and hold the button for about 2 seconds
until the printer pulls in the paper and starts printing.
Note: If you press the button without any paper in the manual feeder, the
printer will automatically use paper in the automatic paper feeder.
7. The paper exits through the face-up output slot with the printed side
up.
Notes:
• The face-up output slot may not hold the printed pages properly.
• The printed pages will not stack in the face-down stacker unless you change the
output lever position. After you finish using the face-up output slot, you must
change the position of the output lever to the normal position by pushing up.
ERROR
PAPER
READY
Operating your printer
2.9
Advertisement
Table of Contents
