Satec PM135P Installation And Operation Manual page 5

Connecting the PM135 Unit
To connect the PM135:
1.
2.
3.
4.



5.
6.
7.
PM135 Powermeter Series
Mounting two PM135 side by side
Ensure that all incoming power sources are OFF.
Check that you have the appropriate power supply.
Connect to the external CT by passing the external
CT wire through the meter CT core. Observe the
arrow that indicates the current direction.
In case of a retrofit application where each external
CT ends with two wires:
Pass one wire through the meter CT core.
Connect the wire to one of the meter termination
screws.
Connect the second wire from the external CT to
the termination screw.
Connect the measured voltage inputs
Connect COM1 – RS-485 communication port
Connect the Power
2
mm /14AWG-dedicated wires.
Supply inputs using 1.5
5