Axminster BS11 Manual page 23

Fig 48-49-50
Fence Assembly
The fence has two positions, vertical for guiding large timber
through and the horizontal position for cutting narrow pieces.
To swop between the two, first remove the rear fence guide,
see fig 51 loosen the two clamping knobs (A) behind the fence
casting, see fig 52 sufficiently to remove the fence. Turn the
fence to the horizontal position, insert the two bolt heads into
the fences 'T' slot and slide on. Replace the rear guide, making
sure guide is touching the back of the table then tighten the
two clamping knobs, see figs 53-54-55.
Fig 51
Rear fence guide
Access port
Clamping bolt
Specific Operating Instructions
Clamping bolt head
Guide through large pieces
Guide through narrow pieces
Table Inserts
The bandsaw comes with two table inserts, one for wood and
one for cutting plastic/metal. The difference between the two is
one has a narrow cutout slot for cutting plastic/metal, see fig 56
-57 on page 24.
PLEASE NOTE: The inset for cutting plastic/metal only
comes with the BS11-INV which has the variable speed
funtion.
23
Fig 52-53-54-55
A
Fence 'T' slot
Continues Over....