Adjusting The Fabric Clamps - DURKOPP ADLER 559 Instruction Manual

20. Adjusting the fabric clamps

2
46
1
Caution: Danger of injury !
Switch the main switch off.
Adjust the fabric clamps only with the machine switched off.
Standard checking
Between the needle 2 and the upper fabric clamp 1 there should be a
distance of 1 mm over the whole length and in the eyelet.
–
Press key "P".
–
Select the menu "150".
–
Enter "+ 0.5".
–
Select the menu "162".
–
Set the cutting area to "0.7".
–
Insert the clamping plates.
–
Insert a new needle.
–
Check the distance between the upper fabric clamp 1 and the
3
needle 2.
Correction
–
Loosen screws 3 (underside).
–
Align the clamp bow 7 with fabric clamp 5 laterally to the needle.
–
Tighten screws 3.
–
Loosen screws 4.
–
Align the clamp arm 6 with fabric clamp 5 in the eyelet as to the
needle.
–
Tighten screw 5.
6 5 4 7 3