Spectrum Industries 55490 Assembly Instructions

Assembly Instructions Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts
or accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
(1) 0131972
Wall Hanger Bracket
(1) 0132217
Tube Spacer
1. Install wall hanger bracket
Wood stud wall
Electric
drill
1. Locate stud in wall. Position the wall hanger bracker at
the desired height on wall.
2. Level the bracket.
3. Using a drill with a Phillips driver, install the wall hanger
bracket onto the wall with (2) #14 x 1-3/4" PHSM screws.
Figure 1.1. Tighten securely.
(2) #14 x
1-3/4" PHSM
Figure 1.1
(2) 021588
8-32 Keps nut
(2) 0101381
#14 x 1-3/4" PHSM
Phillips
Level driver
Wall Hanger Bracket
W a
l l
Wall Hanging Kit
for Connect10 Locker
• One 55490 kit will attach one locker to a wall
• One 55490 kit required per locker
• To fully comply with ADA guidelines, it's recommended the locker be hung
above base cabinets or other permanent structure that extends to the floor.
• 175 lb [79.5 kg] weight capacity. Do not exceed this limit.
Concrete wall
Electric 3/16"
hammer masonry
drill drill bit
1. Position the wall hanger bracker at the desired location and
height on the wall.
2. Level the bracket.
3. Mark the (2) mounting hole locations onto the wall.
4. Using a hammer drill with 3/16" masonry drill bit, drill into the
wall at the (2) marked locations. (Approximately 1-1/4"D).
5. Install the wall hanger bracket with (2) 1/4" x 1-1/4" Tapcon
fasteners. Figure 1.2. Tighten securely.
(2) 1/4" x 1-1/4"
Tapcon Hex
screw
55490
(2) 055699
1/4" x 1-1/4" Tapcon
Hex screw
Level
Wall Hanger Bracket
Figure 1.2
0190202 Page 1 of 3
Ratcheting
wrench
with 5/16"
socket
W a
l l