Magura TS6 Owner's Manual page 24

I
NSTALLATION
Assigning the arrow keys on the eLECT remote control
The front arrow key of the eLECT remote control is best assigned to
your suspension fork, and the rear key to your rear shock.
This assignment can be changed depending on where your eLECT
remote control is mounted.
Press the round button on the remote control 1×.
The remote control LED flashes green and red.
The eLECT remote control is "awake".
Press and hold the round button and the front arrow key on the remote
[ ]
control for at least 2 s. N6
The remote control LED is steady red – approx. 2 s.
The remote control LED flashes green and red.
The front arrow key is assigned to the suspension fork.
24
Synchronising the eLECT remote control
The eLECT remote control and the eLECT unit must be synchronised
(paired) when used for the first time and after replacing the battery.
Malfunctions.
[ ]
N2
Make sure that the eLECT remote control is at least 40 m away from
other ANT+ devices (navigation unit, speedometer, PC etc.).
Press and hold the button on the eLECT unit (suspension fork and if
applicable rear shock) for at least 8 s.
The eLECT unit LED is steady red.
The suspension fork and if applicable the rear shock are ready for
synchronisation.
Press the round button on the remote control 1×.
The remote control LED flashes green and red.
The eLECT remote control is "awake".
Press and hold the two arrow keys on the remote control for at least
[ ]
3 s. N3
The remote control LED is green and red.
Synchronisation is performed - this may take up to 30 s.
The eLECT unit LED flashes red 3×
the remote control LED flashes green
Synchronisation is completed.
[ ]
N1
[ ]
N2
[ ]
N4 and
[ ]
.
N5