Advertisement
41. Mark & drill the front hole using a 29/64" drill bit. Once drilled,
install the 7/16" x 1" fine thread bolt, washer, & nut.
42. Install the new Skyjacker coil springs using the OEM upper &
lower rubber isolator pads. (See Photo # 37) Once installed,
carefully load the rear suspension & attach the rear track bar to
the new Skyjacker bracket using the OEM hardware.
43. Insert the 5/8" polyurethane hourglass bushings into each end of
the new Skyjacker sway bar end links. Insert the 1/2" x 1 1/2"
sleeve into each bushing. Attach the new sway bar end links to
the OEM mounts using the 1/2" x 3" fine thread bolts, washers, &
nuts. (See Photo # 38)
44. Install the new Skyjacker rear brakeline relocation bracket. Attach
the bracket to the axle using the OEM hardware & attach the
OEM brakeline to the new Skyjacker bracket. (See Photo # 39)
45. Lower the vehicle to the ground & install the new Skyjacker rear
shocks.
I-C766SP
Photo #37
Photo #38
Photo #39
Pg 12
Advertisement
