Skyjacker FJ730ST Installation Manual

Part # Description
530STS Toyota Front Strut
FJ25R 2.5" REAR COILS FJ
SBE702 END LINKS REAR
-Skyjacker strongly advises taking extreme caution when working with loaded coil springs to
prevent accident or harm.
Front:
1. With vehicle on flat level ground, set the emergency brake and block the
rear tires.
2. Raise the front of vehicle in the center of the front cross member using a
floor jack.
3. Support the vehicle on the frame cross member so that the front tire/wheels
are off the ground. Remove front wheels.
4. Remove the ABS line from the upper A-Arms using 10mm wrench. (See
Photo #1) Disconnect ABS/Brake line from steering knuckle.
5. Remove sway bar end links using 17mm. (See Arrow in Photo #2)
6. Remove cotter pin from outer tie rod. Disconnect tie rod using 12 mm sock-
et. (See Photo #3)
7. Remove cotter pin from upper ball joint, remove using 19mm socket. (See
Photo #4)
8. Locate lower shock mounting bolt. Remove lower shock mounting bolt
using 19mm socket. (See Photo #5)
9. Disconnect upper shock assembly from frame using 14mm wrench. (See
Photo #6)
10. Remove factory strut assembly.
Photo #4
I-FJ730ST 7-07
Qty
2
1
1 pr
IMPORTANT NOTES
Instructions:
Photo #5
Toyota FJ Cruiser 3"
Performance Series Strut Kit
Installation Guide
Part# FJ730ST
Photo #1
Photo #2
Photo #3
Photo #6
Pg 1