Advertisement
27. Reinstall the OEM sway bar using the new Skyjacker drop
brackets. The brackets will install between the sway bar & the
OEM mount on the frame using the 10mm x 30mm hardware
supplied. (See Photo # 26) Install the new Skyjacker sway bar
end links. Be sure to install the end link with the pivoting end
at the A-arm. The gold washer should be on top of the A-arm,
with the nut on the bottom. (See Photo # 27)
Pick-Up Models:
28. Raise the rear end of the vehicle & properly support using jack
stands. Disconnect the rear shocks using a 21mm socket &
U-bolts. Install the new Skyjacker 4.5" rear blocks (thick end
towards the rear) along with the new Skyjacker U-bolts. (See
Photo # 28) If installing Skyjacker Softride rear springs, simply
remove the OEM spring & replace. Note: If changing rear leaf
springs, it will be necessary to lower the gas tank down to gain
access to the forward spring bolt. Note: If your model is
equipped with rear ABS lines, remove the ABS line from the
plastic connector on the frame & attach the ABS line to the
outside of the new U-bolts using the supplied plastic ties. (See
Photo # 29)
29. Lower the vehicle to the ground & skip to step # 43.
SUV Models:
30. Remove the rear shocks using a 21mm socket. Disconnect the
rear sway bar end links. (See Photo # 30)
31. Loosen the lower & upper control arm bolts using a 21mm
socket. (See Photo # 31)
32. Disconnect the emergency brake cable from the driver side axle
& passenger side frame using a 13mm socket. Disconnect the
brakeline from the center of the axle.
Photo #30
I-C766SP
Photo #31
Photo #26
Photo #27
Photo #28
Photo #29
Pg 10
Advertisement
