Skyjacker F4621A Installation Instructions Manual

www.skyjacker.com
REquIRED TOOL LIST:
• Safety Glasses
• Metric / Standard Wrenches & Sockets
• Spring Compressor
• Floor Jack
• Jack Stands
• Measuring Tape
• Torque Wrench
• Transmission Jack
• 10,000 lb Shop Press
Before beginning the installation, thoroughly & completely read these instructions & the enclosed
driver's WARNING NOTICE. Affix the WARNING decal in the passenger compartment in clear view
of all occupants. Please refer to the Parts List to insure that all parts & hardware are received prior
to the disassembly of the vehicle. If any parts are found to be missing, contact SKYJACKER ®
Customer Service at 318-388-0816 to obtain the needed items. If you have any questions or
reservations about installing this product, call SKYJACKER ® Technical Assistance at 318-388-0816.
Make sure you park the vehicle on a level concrete or asphalt surface. Many times a vehicle is not
level (side-to-side) from the factory & is usually not noticed until a lift kit has been installed, which
makes the difference more visible. Using a measuring tape, measure the front & rear (both sides)
from the ground up to the center of the fender opening above the axle. Record this information
below for future reference.
Driver Side Front:
Driver Side Rear:
IMPORTANT NOTES:
• This lift is determined from the amount of lift to the front of the vehicle, while only lifting the rear
to a position level with the front.
• If larger tires (10% more than the stock diameter) are installed, speedometer recalibration will be
necessary. Contact your local Ford dealer or an authorized dealer for details.
• After installation a qualified alignment facility is required to align the vehicle to factory
specifications.
I-F4621 REV1 3-11
2004 - 2008 Ford F-150 2WD
6" Suspension Lift

Installation Instructions

Passenger Side Front:
Passenger Side Rear:
Pg 1