Installation; Wall Mount; Eave Mount - Heath Zenith 5525 Operating Instructions Manual

INSTALLATION

CAUTION: Keep the sensor at least 1" (25 mm)
away from the bulbs.
CAUTION: To Avoid Fire Or Burn Hazards:
• Allow fixture to cool before touching. The bulb and
the fixture operate at high temperatures.
• Keep fixture at least 2" (51 mm) from combustible ma-
terials. Do not aim at objects closer than 3 feet (1 m).
• Use only T3, 250W (maximum) tungsten halogen
120 VAC lamps.
For easy installation, select an existing light operated
by a wall switch for replacement. IMPORTANT: Do NOT
use with dimmers or timers.
For best performance, mount the fixture about 8 feet
(2.4 m) above the ground. NOTE: If fixture is mounted
higher than 8 feet (2.4 m), aiming the sensor down will
reduce coverage distance.

Wall Mount

NOTE: Light fixture and sensor should be mounted as
shown above when installed (depending upon type of
installation).
• Note the position of the various parts of the fixture for
Before installing the light fixture under an eave, the
sensor head must be rotated as shown in the next
two steps for proper operation and to avoid the risk of
electrical shock.
IMPORTANT: For proper under-eave operation, install
light shield (included). See Light Shield Installation
for details.

Eave Mount

2
the type of installation for your application and adjust
the lamp head and sensor as shown below.
Wall Mount
Lens Retainer
Light Shield,
with opening
at this side
For eave mount only:
1. Swing the sensor head towards the clamp screw
joint.
Clamp Screw
2. Then rotate the sensor head clockwise 180° so
the controls face down.
Light Shield
Opening
If the sensor pops out of the ball joint, loosen the
clamp screw and push the sensor back into the ball
joint. Tighten the clamp screw when done.
Eave Mount
Lens Retainer
Controls
Controls
Controls
204055-02