Setting Up Telephone; Attach The Stand - Nortel Enterprise Edge M7324N User's Card Manual

Setting up the telephone
Connecting the cords
1
Press here firmly
until it clicks, to

attach the stand.

Press here to
remove the stand.
Notice
Page 4 Enterprise Edge M7324N User Card Page 4 Enterprise Edge M7324N User Card
2
These telephones now conform to the latest standards in
relation to the positioning of Q and Z on the number buttons.
The Q appears on button number 7 and the Z appears on
button number 9.
ATTENTION Before attempting to carry
out any work on the telephone, ensure
that the line cord is unplugged from the
wall socket.
To remove any of the cords, squeeze the
release latch on the plug and gently pull
the plug from the socket.
Connect the handset cord to the jack
labelled with the telephone icon and
route the cord as shown.
If you are using a headset, route the
cord along the channel in the base and
connect the cord to the telephone jack
that is marked with the headset icon.
Route the line cord through the stand
and connect the cord to the telephone
jack that is marked with the jack icon.
Attach the stand using either pair of
slots; to raise the back of the telephone
to its highest position, use these slots.
Once the above work is complete, p
the line cord back into its wall socket.
P0908520 Issue 02
lug