Starting The Generator; Igen1200 Starting - Westinghouse iGen2200 Instruction Manual

6. Remove the fuel cap by unscrewing it anti-
clockwise.
7. Slowly add fuel into the fuel tank. Be careful not
to overfill the tank. The fuel level should NOT be
higher than the red ring inside the fuel strainer
(see Figure 12).
8. Replace the fuel cap by screwing it on clockwise
and turn the fuel cap vent anti-clockwise to the
OFF position (if equipped).
Figure 12 – Maximum Fuel Fill Level
CAUTION
Avoid prolonged skin contact with
fuel. Avoid prolonged inhalation of
fuel vapours.
NOTICE
Do not overfill the fuel tank. Spilt fuel may damage
some plastic parts.

STARTING THE GENERATOR

Before attempting to start the generator, verify the
following:
• The engine is filled with engine oil (see Checking
Engine Oil on page 30).
• The generator is situated in a proper location
(see Location Selection on page 19).
• The generator is on a dry surface (see Weather
and Dry Surface on page 20).
• All loads are disconnected from the generator
(see No Connected Loads on page 20).
OPERA TION
DANGER
Never use the generator in a location
that is wet or damp. Never expose the
generator to rain, snow, water spray
or standing water while in use. Protect
the generator from all hazardous
weather conditions. Moisture or ice
can cause a short circuit or other
malfunction in the electrical system.
Never operate the generator in
an enclosed area. Engine exhaust
contains carbon monoxide. Only
operate the generator outside and
away from windows, doors and vents.
NOTICE
The generator is equipped with a low oil shutdown
switch. If the oil level becomes too low, the engine
will shut down automatically and cannot be re-
started until the oil is filled to the proper level.
Be sure the engine has the proper oil level before
using. Failure to verify that the engine has the
proper oil level could result in severe engine
damage or shorten the engine life.
Disconnect all loads from the generator before
starting. Failure to verify all loads are disconnected
prior to starting the generator could result in
damage to the connected electrical devices.

iGen1200 Starting

The primary touch points that the user needs
to interact with when starting the generator are
identified with yellow coloured markings.
1. Turn the fuel cap vent to the ON position (see
Figure 13).
Figure 13 – Fuel Cap Vent in the ON Position
21