Fuel Strainer Maintenance - Westinghouse iGen2200 Instruction Manual

iGen4500: Remove the air filter cover by turning
the twistlocks anti-clockwise and tipping the
cover forwards (see Figure 36). Clean the air
filter cover with a rag and place it aside.
Figure 36 - iGen4500 Removing the Air Filter Cover
5. Remove the foam air filter element while
taking care to note its shape and orientation
(see Figure 37). The air filter element must be re-
installed later in the same position.
Figure 37 – Removing the Air Filter Element
6. Wash the air filter element in a solution of
household detergent and warm water or
alternatively in non-flammable solvent. Slowly
squeeze the foam in the liquid for a thorough
cleaning action. Then remove the foam and
squeeze out the liquid.
NOTICE
NEVER twist or tear the air filter element during
cleaning or drying. Apply only a slow and firm
squeezing action.
7. Rinse the air filter element by immersing it in
fresh water and applying a slow squeezing
action.
MAINTENANCE
NOTICE
Never dispose of the used cleaning solution or
solvent by dumping it into a sewer, on the ground,
into groundwater or into a waterway. Always be
environmentally responsible. Follow the guidelines
of the governmental agencies for proper disposal
of hazardous materials. Consult local authorities
or reclamation facility.
8. Dry the air filter element by repeatedly applying
a slow firm squeezing action.
9. Coat the air filter element in clean engine oil and
then thoroughly squeeze out the excess liquid.
10. Re-install the air filter element inside the air filter
housing while taking care to ensure that the
element is correctly positioned.
11. Re-install the air filter and engine access covers.

FUEL STRAINER MAINTENANCE

Check and clean the fuel strainer after every 100
hours of use or 6 months. It is recommended that
this maintenance task also be performed each time
when filling with fuel from any source other than
directly from a service station bowser.
1. Stop the generator, if running.
2. Allow the generator to cool down until the
muffler access cover is cool to the touch.
3. Remove the generator to a flat surface.
4. Clean area around the fuel cap.
5. Turn the fuel cap vent to the ON position, if
equipped.
6. Remove the fuel cap and set it aside on a clean
surface.
7. Remove the fuel strainer by hand from inside the
filler hole on top of the fuel tank (see Figure 38)
taking care not to tear or otherwise damage the
fine mesh screen. Keep the fuel strainer vertical
so that any trapped liquid or solids do not spill
onto the generator.
Figure 38 – Removing the Fuel Strainer
33