Installation; Unpacking And Inspection; Unpacking; Inspection - ABB XSeries G4 6200 User Manual

2 Installation

This chapter provides the user with the information for installation and setup of the
G4 EX. By the time the user has finished the chapter, they will have the G4 EX
unpacked, installed, field wired and ready for operation. For safe and trouble free
installation, follow all instructions and advisories.
2.1

Unpacking and inspection

2.1.1 Unpacking

The G4 EX and RTD are shipped in a specially designed shipping carton which
contains the unit, mounting brackets, parts list and wiring and interconnect
diagrams. The solar panel and the battery pack with applicable hardware are
shipped in a separate carton.
Carefully remove the items from each carton.

2.1.2 Inspection

-
-
-
-

2.1.3 Damaged components

If any components have been damaged or if there are noticeable defects, notify
the Totalflow representative. Keep all shipping materials for the carrier's
inspection. Totalflow will arrange for immediate repair or replacement. See the
Getting Help section at the beginning of the manual.

2" Pole mount installation

2.2
The following information presented in this document will detail the steps for
mounting the G4 EX to a 2 inch mounting pipe using the mounting kit assembly
provided with the device. The G4 EX has three mounting types that can be
performed, based on the transducer that the user has received. It must be noted
that the transducer should be mounted above the meter run to allow adequate
slope between the manifold and the orifice fittings.
The installation instructions that follow can be used for either a side pole mount or
a stand-alone pipe mount configuration.
Before beginning these steps, review the procedures and the materials required
for installation.
2104349 rev. AD
Read through this chapter before beginning the installation.
This will give the user the ability to plan their specific
installation. Additionally, before beginning, refer to the wiring
diagrams delivered with the G4 EX. The user can store these
drawing under the Drawing tab in the back of the manual.
Inspect the shipping carton for damage. If the shipping carton is damaged,
keep it until the contents have been inspected for damage.
Inspect the unit's exterior for dents, chipped paint, etc.
Inspect the LCD window for breakage.
Visually inspect the electronic boards, cables and EXIMV for damage.
Page 2–1