2) Upon location, press the Reset button for approximately five seconds. The
4.4.1.2
1) Open the door to the unit. Ensure that there is voltage on the battery and
2) Remove power to the board, and then reconnect. This will initiate a warm
4.4.2 Software Warm Boot
There are three methods of warm booting the system from a software standpoint:
4.4.2.1
1) Open PCCU32. The user needs to ensure that they are not connected
2) Click the 32-Bit Loader icon on the toolbar. This takes the user to the 32-Bit
3) Within the screen, the user needs to select the Reload radio button.
4) Ensure that all of the checkmarks are removed from the various software
5) Select the needed connection type from the available drop-down menu.
6) Upon completion, click the Start button.
2104349 rev. AD
Figure 4–1 Reset Button Location
unit will warm boot.
Method 2
that the jumper is enabled.
If either of these conditions are not met, do not attempt a
warm boot. Continuing with this process without both
conditions being met will result in a cold boot and all
historical data will be lost.
boot.
Method 1
initially and are at the Totalflow splash screen.
Loader screen.
option. Once this has been accomplished, place a check in the options list
beside Shutdown Flash and Start Flash.
J19
COMM1
9
8
7
6
J9
5
1
4
3
3
S3
2
1
RESET
-
2
1
+
J16
PWR
Page 4–3