AnyTone AT-D878UV Operating Manual page 31

SCM CO: When scanning and stopping for signal, stays at the channel
until the signal disappears, and resumes scan 2s later.
SCM SE: When scanning and stopping for a signal, will terminate the scan.
This function is only valid for a VFO scan.
Mic Level
(27)
Allows to adjust the Microphone gain, level 1 is the lowest, level and 5 is
highest gain.
DTMF Speed
(28)
Offers DTMF encode speed which will help the receiver decode
successfully, 50~500ms are the options.
FM Radio
(29)
Turn on or off the FM radio.
FM Radio Moni
(30)
Radio Mon On: When FM radio is used, you can still receive or transmit on
the channel.
Radio Mon Off: When FM radio is used, the radio will not permit a
transmission or reception.
Man Down Alarm
(31)
When the function is on, the radio will start alarm if the radio is falling to the
ground. Raise the radio to stop the alarm.
When GPS is on and positioning successfully, it will auto send out the GPS
information when the radio starts the alarm.
Start Up Pwd
(32)
On: Set up the password for start up. You need to input the password to
power on the radio.
Off: No password is required for the radio power on start up.
The password shall be set up in CPS-Optional Setting-Power on-Power-on
Password Char.
AuRepeater A or B (For VFO A or B)
(33-34)
Turn on the Auto Repeater function, the TX frequency in VFO mode will
auto increase or reduce frequency base on the set up offset frequency in
CPS.
Off: Turn off the function.
Positive: TX frequency= RX frequency + Offset frequency.
25
7. MAIN MENU FUNCTIONS
AT-D878UV Digital DMR and Analog UHF/VHF Two Way Radio