Intended Use; Operator Training; General Preventive Measures - Ravaglioli RAVTD1760 WS Instruction Manual

RAVAGLIOLI S.p.A.

1 INTENDED USE

RAVTD1760WS and RAVTD1780WS systems are machines for the detection of all vehicle
special angles.
Angles are detected by four detectors with microprocessor technology and infrared
measurement system, and data transmission (without any cable connection between
detectors).
The data of front cabin detectors are transmitted VIA RADIO through modules
.
Vehicle max. allowed wheelbase length for data transmission and angle measurement is 4.5
m.
Machine operational temperature range: 0 to 40°C.

2 OPERATOR TRAINING

The machine must be used by specifically trained and authorised personnel, only. To ensure
proper machine use and that measurements can be efficiently taken, operators must be correctly
trained and acquire the skills consistent with the instructions provided by the manufacturer. In
case of any doubts relating to machine use and maintenance, refer to the instruction manual and
then, if such doubts persist, contact an authorised after-sales centre or RAVAGLIOLI S.p.A.
technical assistance directly.

2.1 General Preventive Measures

•
During operation and maintenance of this machine, always abide by the safety and
accident-prevention regulations in force.
•
The machine must only be used by adequately trained and authorised persons.
•
This machine must only be used for the purpose for which it was expressly intended.
RAVAGLIOLI S.p.A. declines all liability for injury or damage to persons animals and
things caused by improper machine use.
•
Accessories and spare parts must be fitted by persons authorised by RAVAGLIOLI
S.p.A. and only original spare parts and accessories must be used.
•
The machine must only be operated in places where there is no danger of explosions
or fire.
•
Removal or changes made to safety devices, or warning signals on the machine can
cause serious hazards and represent a violation of European safety regulations.
•
Before doing any maintenance jobs on the system, always disconnect the power
supply.
In case of doubt, do not interpret, but contact RAVAGLIOLI S.p.A. technical
assistance in order to obtain instructions suitable for performing operations in total
safety.
•
Do not allow unauthorised personnel to come near the wheel aligner during use.
Page 4/52
RAVTD1760 WS – RAVTD1780 WS
RAVAGLIOLI S.p.A. - Via I° Maggio, n° 3 (Pontecchio Marconi)
40037 Sasso Marconi (Bologna - Italy)
Tel. 051/ 67.81.511 – Fax 051/ 84.64.67 E-mail: rav@ravaglioli.com
Instruction manual
Code M0197 - rev.1.0
(11/2010)