Detector Keypads; Led Indicating Levelling And Tolerance During Adjustment - Ravaglioli RAVTD1760 WS Instruction Manual

RAVAGLIOLI S.p.A.

3.6.4 Detector Keypads

(A) Green LED
Legend of Figure 5:
A - •
B - •
•

3.6.5 LED indicating Levelling and Tolerance during Adjustment

Detectors (see par. 3.6.1 and 3.6.2) are equipped with LED indicators for their correct
levelling and for tolerance during adjustment.
Levelling indicator
•
RED LED on detector is not levelled
•
RED LED flashing and GREEN LED steady on
•
GREEN LED ONLY is flashing
•
RED LED flashing and GREEN LED steady on
•
RED LED on detector is not levelled
Tolerance indicator during adjustment
•
GREEN LED flashing
•
RED LED flashing and GREEN LED steady on
tolerance
•
RED LED on measurement is NOT within tolerance
Note: during front adjustment, if you want to observe tolerance onto LEDs, take the red selection
frame on the value you are adjusting (see 8.12 on page 37).
During rear adjustment, on the contrary, tolerance is indicated both on horizontal LEDs (toe) and
vertical LEDs (camber).
LEDs on
FRONT
detectors
Tolerance
TOE or
CAMBER or
CASTER
RAVTD1760 WS – RAVTD1780 WS
Figure 5
KEYS
Green LED on:
Red LED steady on:
Red LED flashing:
detector is levelled
measurement is within tolerance, exactly at the centre
RAVAGLIOLI S.p.A. - Via I° Maggio, n° 3 (Pontecchio Marconi)
40037 Sasso Marconi (Bologna - Italy)
Tel. 051/ 67.81.511 – Fax 051/ 84.64.67 E-mail: rav@ravaglioli.com
(B) Red LED
Detector switch-on key.
If pressed at the same time, they allow detector
manual switching off.
detector battery is under charge
detector is on
detector is flat (when battery residual charge is
lower than or equal to 30%); it will turn off after
a few minutes
detector is close, but not levelled
detector is close, but not levelled
measurement is within
LEDs on
REAR
detectors
Instruction manual
Code M0197 - rev.1.0
DESCRIPTION
RAVTD1780WS , only
CAMBER tolerance
TOE tolerance
(11/2010)
Page 9/52