Preliminary Operations; Vehicle Check Preliminary Operations; Run-Ou Preparation - Ravaglioli RAVTD1760 WS Instruction Manual

RAVAGLIOLI S.p.A.

8.4 Preliminary Operations

8.4.1

Vehicle Check Preliminary Operations

Before starting the check of vehicle geometrical alignment, the following checks shall be
carried out:
• Check and, if necessary, eliminate any clearance on suspensions and on steering linkage
• Check and, if necessary, eliminate any hard spot or yielding of suspension spring parts.
• Adjust tyre pressure to the values specified by the manufacturer.
• Position and distribute any load envisaged by the manufacturer.
8.4.2 Run-Out Preparation
After having displayed vehicle technical specification page (see par. 8.3 on page 22), you can
prepare vehicle for Run-Out procedure. Proceed as follows:
Fit clamps and detectors onto wheels
-
Raise vehicle from lift platforms (if an Run-Out with raised wheel is carried out, see par.
-
8.5.1)
Lock rotating plates
-
rear sensor
battery charge %
Note: during this phase, the images showing the 4 sensor batteries with the residual charge
% are displayed.
RAVTD1760 WS – RAVTD1780 WS
Figure 26
DETECTOR
KEYPAD
RAVAGLIOLI S.p.A. - Via I° Maggio, n° 3 (Pontecchio Marconi)
40037 Sasso Marconi (Bologna - Italy)
Tel. 051/ 67.81.511 – Fax 051/ 84.64.67 E-mail: rav@ravaglioli.com
PC KEYBOARD
Raised wheel Run-Out selection
Instruction manual
Code M0197 - rev.1.0
(11/2010)
front sensor
battery charge %
DESCRIPTION
It goes back to previous page
(par. 8.5.1 on page 24)
or thrust Run-Out
(par. 8.5.2 on page 27)
It continues to next page
(Run-Out)
(par. 8.5 on page 24)
Page 23/52