Front Axle Adjustment - Ravaglioli RAVTD1760 WS Instruction Manual

RAVAGLIOLI S.p.A.

8.12 Front Axle Adjustment

Front axle adjustment procedure is launched by selecting in the rear axle adjustment page
(Figure 53) after having carried out adjustment preliminary operations (see par. 8.10 on page
36).
To adjust angles, the correct sequence is the following: CASTER – CAMBER – TOE.
WARNING: When entering this stage, caster values are "FROZEN".
To "de-freeze" these values, you can press Shift+F5 at the same time when the measurement
selection "R" is on caster measurement values, or select F2 to display a menu page with
additional functions (par. 8.13 on page 38). Now select "Caster Adjustment".
Once caster values have been adjusted or, even if they are not adjusted as they are deemed to
be correct, it is recommended to "FREEZE" again these values. This procedure prevents caster
values from varying in case detectors are inadvertently moved.
To this end, take measurement selection "R" (see Figure 52) onto the caster values, and proceed
as described above.
A grid will be displayed onto caster values, to indicate that they are "frozen".
Then adjust front axle
Caster
measurements
Front partial toe
measurements
RAVTD1760 WS – RAVTD1780 WS
Figure 52
DETECTOR
KEYPAD
RAVAGLIOLI S.p.A. - Via I° Maggio, n° 3 (Pontecchio Marconi)
40037 Sasso Marconi (Bologna - Italy)
Tel. 051/ 67.81.511 – Fax 051/ 84.64.67 E-mail: rav@ravaglioli.com
PC KEYBOARD
Instruction manual
Code M0197 - rev.1.0
(11/2010)
Front camber
measurements
DESCRIPTION
Repeat steering procedure.
(par. 8.8 on page34)
It displays options menu.
(par. 8.13 on page 38)
Selection key of the
measurement to be adjusted.
Operations completed !
Customer data entry
(par. 8.14 on page 39)
It repeats adjustment
operations
(par. 8.11 on page 36)
Page 37/52