SelectBlinds CORDLESS LIFT SYSTEM HONEYCOMB SHADE Installation Instructions

CLEANING INSTRUCTIONS
Honeycomb shades are made of an anti-static, dust resistant fabric which repels dirt
and dust. For most of these fabrics, the following options are available if your shade
needs cleaning.
DUSTING: Regular light dusting with a feather duster is all the cleaning that is
needed in most circumstances.
VACUUMING: Use a hand-held vacuum with low suction for more thorough dust
removal.
SPOT CLEANING: Use the following steps for spot cleaning: (1) Prepare a solution
of warm water and mild dishwashing detergent. (2) Dampen a clean cloth in the
solution and ring it out. (3) Dab the spot with the dampened cloth until it is gone.
DO NOT RUB THE FABRIC. (4) Allow the shade to dry in the completely lowered
position.
CAUTION: Avoid creasing Blackout fabrics during cleaning.
ULTRASONIC CLEANING: Standard shades, except those made with Blackout Lining
can be ultrasonically cleaned by a professional.
 Specify that a mild detergent be used.
 Never immerse the headrail in the solution.
Dry the shade completely in the lowered position.

CAUTION: Do not ultrasonically clean Blackout fabrics. Do not immerse headrail.
WARNING
Inner or exposed cords can pull out to form a loop, which can STRANGLE a young
child.
 Children can climb furniture to access inner or exposed cords.
Move cribs, playpens, and other furniture away from window
coverings.
Always keep cords out of the reach of children.

CANADIAN RESIDENTS ONLY:
For more safety information
call 1-866-662-0666 or go to
www.healthcanada.gc.ca/blindcords
C8-10-4480 • 5/18
5
INSTALLATION INSTRUCTIONS
HONEYCOMB SHADES
CORDLESS LIFT SYSTEM
Thank you for your purchase. This shade has been custom built for you from the
highest quality materials. To avoid errors and save valuable time, please read these
instructions before installing your new shade.
TOOLS YOU WILL NEED
1. Pencil or Marker
2. Measuring Tape
3. Phillips Screwdriver
4. Carpenter's Level
5. Power Drill
6. Mounting Fasteners
GETTING STARTED
All the required installation components are wrapped in your package along with
these instructions. Check that the parts you have correspond to the parts shown
below.
PARTS
Installation Brackets .......................................................

 Screws .........................................................
 Handle(s) ......................................................
MOUNTING THE BRACKETS
The installation brackets may be used for INSIDE or OUTSIDE mounts.
Mounting the brackets level is essential for proper operation of the shade. Shim the
brackets if necessary to achieve a level alignment.
The bracket requirements and placements are the same for inside and outside mounts.
Refer to the following spacing diagram and bracket requirement chart.
Installation Bracket Requirement Chart
Shade Width
up to 38"
38-1/8" to 72"
Over 72-1/8"
6
Brackets Required
2
3
4
1