Table of Contents
Advertisement
5. Pull the starter rope slowly until resistance
is felt. Continue pulling until the notch
on the starter pulley aligns with the hole
on the recoil starter. At this point, the
intake and exhaust valves are closed and
will help protect the engine from internal
corrosion.
6. Cover engine to keep out dust.
Troubleshooting
Engine will not start using recoil starter:
1. Is the engine switch in the ON position?
2. If equipped with oil alert, does the oil alert
lamp flash when the starter is operated?
3. Is the fuel valve on?
4. Is there fuel in the fuel tank?
5. Is petrol reaching the carburetor? To
Specifications
DIMENSIONS AND WEIGHT
Description code
Length x Width x Height
Dry weight
Engine type
Displacement
[Bore x Stroke]
Max. output
Max. torque
Fuel consumption
Cooling system
Ignition system
PTO shaft rotation
NOTE: Specifications may vary according to the types, and are subject to change without notice.
check, loosen the drain screw with the fuel
valve on.
6. Is there a spark at the spark plug?
a) Remove the spark plug cap. Clean any
dirt from around the spark plug base,
then remove the spark plug.
b. Install the spark plug in the plug cap.
c. Turn the engine switch on.
d. Ground the side electrode to any
engine ground, and pull the recoil
starter to see if spark jumps across
the gap.
e. If there is no spark, replace the plug.
If OK, reinstall the spark plug and try
to start the engine again according to
the instructions.
7. If the engine still does not start, take the
engine to an authorized Honda dealer.
GX200
362 x 262 x 346 mm
(14.25 x 10.31 x 13.62 in)
16.0 kg (35.2 Ib)
4-stroke, overhead valve, single cylinder
196 cc (11.9 cu in)
[68 x 54 mm (2.677 in x 2.125 in)]
5.0 HP/3,600 rpm
1.26 kg (9.15 ft-lb)/2,500 rpm
1.7 L/hr /3,600 rpm
Forced air
Transistorized magneto
Counterclockwise
16
Advertisement
Table of Contents
Troubleshooting
