How To Assemble And Operate The Vacuum - Carpet Pro CPBU-1 Owner's Manual

How to Assemble and Operate the Vacuum

Note: Do not plug in the vacuum until it is completely assembled.
Handle Assembly
The vacuum, hose, wand and accessories are
packed separately.
1. Remove the handle screw from the rear of handle
unit (Fig. 1).
2. Remove and discard cardboard.
3. Assemble the handle as shown in (Fig. 1).
4. Using a Phillips screwdriver, tighten the handle
screw (Fig. 2). Note: Do not overtighten.
5. Place the dusting brush and crevice tool in areas
as shown.
Please pay special attention to these hazard alert boxes, and follow any
instructions given. WARNING statements alert you to such hazards as fire,
electric shock, burns and personal injury. CAUTION statements alert you to
such hazards as personal injury and/or property damage.
WARNING
Electrical Shock Hazard
DO NOT plug into the electrical
supply until the assembly is complete.
Failure to do so could result in
electrical shock or injury.
Handle
Screw
Cardboard
ASSEMBLY INSTRUCTIONS
Handle
Cardboard
HANDLE ASSEMBLY
-6-
5
Screw
Fig. 1
Screw
Hole
Handle
Screw
Dusting
Brush
Fig. 2
D
B
-6-
Crevice
Tool