Lighting Instructions - COZY CF403D-H Installation And Operating Instructions Manual

MODELS:
WARNING:
A. This appliance has a pilot which must be
If you do not
follow these
instructions
B. BEFORE LIGHTING smell all around the
exactly, a fire
or explosion
may result
causing
WHAT TO DO IF YOU SMELL GAS:
property
damage,
personal
injury or loss
of life.
1. STOP! Read the information on the safety label.
2. Set thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. Remove lower front panel.
5. Push in gas control knob slightly and turn clockwise
to "OFF".
Gas Control Knob
HONEYWELL
C TH-TR
ON
OFF
PILOT
Pilot Control Knob
6. Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas,
STOP! Follow "B" in the information on the safety
label. If you don't smell gas, go to the next step.
7. Locate red piezo ignitor button on side of gas control.
Locate pilot behind sight glass. (Follow metal pilot
tube from gas control).
8. Turn gas control knob counterclockwise
"PILOT".
1. Turn thermostat to it's lowest setting.
2. Turn off all electric power to the appliance if service
is to be performed.
3. Remove lower front panel.
1018029-A
LIGHTING INSTRUCTIONS - ( Standing Pilot )
CF403D-H / CF404D-H / CF553D-H / CF554D-H
FOR YOUR SAFETY READ BEFORE LIGHTING
lighted by hand. When lighting the pilot,
follow these instructions exactly.
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier
than air and will settle on the floor.
• DO NOT try to light any appliance.
• DO NOT touch any electric switch.
• DO NOT use any phone in your building.
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions.

LIGHTING INSTRUCTIONS

NOTE:
Knob cannot
be turned from
"PILOT" to "OFF"
unless knob is
pushed in slightly.
Do not force.
to
TURNING OFF GAS TO APPLIANCE
• If you cannot reach your gas supplier, call
the fire department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob
will not push in or turn by hand, don't try to
repair it, call a qualified service technician.
Force or attempted repair may result in a
fire or explosion.
D. Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water.
9. Push in pilot control knob and hold in. Immediately
begin a series of pushing and releasing the red
piezo ignitor button, while observing the pilot through
the sight glass. Continue to spark until pilot is lit.
Continue to hold the pilot control knob in for about
one (1) minute after the pilot is lit. Release the pilot
control knob and it will pop back up. Pilot should
remain lit. If pilot goes out, repeat steps 5 thru 9.
- If knob does not pop up when released, STOP and
immediately call your service technician or gas supplier.
- If the pilot will not stay lit after several tries, turn the gas
control knob to "OFF" and call your service technician
or gas supplier.
10. Turn gas control knob counterclockwise
11. Replace lower front panel.
12. Turn on all electric to the appliance.
13. Set thermostat to desired setting.
4. Push in gas control knob slightly and turn clockwise
to "OFF". Do not force.
5. Replace lower front panel.
Page 12
Back to Index
Pilot Burner
The pilot is
located on the
side of the
burner.
to "ON".