Mira Realm With Diverter - Mira REALM Installation And User Manual

Mira Realm with Diverter

1. Refer to 'Mira Realm, paragraphs 1 to 13' to
install the mixer.
Horizontal Arm
Showerhead
Diverter
Shower Hose
Rigid Riser
Pipe (short)
2. Temporarily fit the rigid riser pipe (short),
diverter, rigid riser pipe (long), horizontal arm
and wall bracket to the shower control outlet
and mark the position of the wall bracket. Use
a spirit level to ensure the pipes are vertical.
Drill the holes and insert the wall plugs.
Note! The vertical rigid riser pipes can be
shortened if required. De-burr the pipe ends
before making the final connection.
Wall Bracket
Showerhead
Rigid Riser
Pipe (long)
Parking
Socket
Sleeve
3. Fix the rigid riser pipes, diverter wall bracket
and tighten the four compression fittings on
the shower control outlet and horizontal arm.
Note! Care must be taken when tightening
compression nuts so that you do not damage
the plated surfaces.
4. Turn on the hot and cold water supplies and
check for leaks.
5. Thoroughly flush the outlet pipework before
connecting the showerhead. Slide the
compression nut and olive over the horizontal
arm and make the connection to the shower
head.
6. Connect the shower hose to the outlet of the
diverter. Make sure that the hose washer is
fitted.
7. Pass the hose through the parking socket.
8. Stretch the parking socket sleeve over the
hose using the split. Squeeze the parking
socket sleeve to fit it into the parking socket.
Ensure the split is at the back.
9. Connect the showerhead. Make sure that the
hose washer is fitted.
10. Locate the showerhead in the parking socket.
11. Before using the shower, refer to section:
'Commissioning'.
Parking
Socket
11