OPERATION
UNDERWATER MODEL PREVENTATIVE MAINTENANCE
After each use, the movable portions of the tool that were exposed to water should be flushed with a water displacing
oil, such as WD-40™. Remove any remaining water and debris as follows:
1. Spray oil throughout all moving parts and any areas exposed to water.
2. Spray oil into the On/Off valve trigger slot area.
3. Dip or spray the entire tool.
4. Cycle the tool hydraulically several times before storing away.
5. Clean the impact mechanism and grease with waterproof grease. See "Impact Mechanism Maintenance" on
page 15
Figure 5 - Underwater Maintenance
14 ► ID07 User Manual