Epson SC-T5100 User Manual page 122

SC-T5100 Series/SC-T3100 Series/SC-T5100N Series/SC-T3100N Series
Settings item
Page Margin
Smoothing
Base Output Size
Using the Menu
Settings value
*
3 mm
5 mm
On
*
Off
*
Auto
A Series
US-ANSI
US-ARCH
B Series (ISO)
B Series (JIS)
Others
User-Defined
User's Guide
Explanation
Select the top, bottom, left, and right margin values.
For a cut sheet, the top, bottom, left, and right margin values are 3
mm regardless of the settings.
This setting is enabled when Resolution is set to Standard, and
resolution not specified in the sent print data. Setting this to On
prints at the maximum resolution corresponding to that paper's
Paper Type settings selected in Paper Source, but depending on
the data, this may result in a long print time, or failures in printing
because of insufficient memory.
The hard clip area of the PS command of the data becomes the
base output size. The actual output size depends on the Page
Margins option. When the data does not contain a PS command,
the smallest rectangle area
including the print object becomes the base output size.
The compatible standard sizes for the selected Paper Source are
displayed, therefore select the Base Output Size. The actual output
size depends on the Page Margins option.
For a cut sheet, this setting is available only when the data does not
contain a PS command. If the data contains a PS command, this
setting is not available, and the hard clip area of the PS command
becomes the Base Output Size.
Select this option when outputting at non-standard sizes. After
selecting this setting, set Paper Width and Paper Height. You can
set in 0.1 mm increments.
The actual output size depends on the Page Margins option.
122
of in the following illustration