Advertisement
For installation in extreme environments,
E
refer to the Reach Spread Lens Kit Installation
Instructions for details on sealing the spread
lens and bezel to prohibit water ingress.
Attach Spread Lenses (Optional)
Exchangeable ColorReach Powercore gen2 spread lenses of 8 °, 13°, 23 °, 40 °, 63 °, and
an asymmetric 17° x 5 ° support a variety of photometric distributions for a multitude
of applications, including spotlighting, wall grazing, and asymmetric wall washing. Each
half of ColorReach Powercore gen2 can be individually addressed and controlled, and
you can install different spread lenses on each half of the fixture's housing for precise
control of light diffusion.
1. Unpack and confirm the contents of the box. Each box contains one lens kit,
consisting of a spread lens with attached rubber gasket, and a bezel with 10
captured mounting screws.
2. Clean both sides of the spread lens and the face of the ColorReach Powercore
gen2 housing, including glass surfaces, using a mild, non-abrasive cleaner. Ensure
that all surfaces are dry, and that the gasket is properly fitted to the lens.
3. Position the spread lens so that the beam-angle designation on the side of the lens
is face up. Handle the spread lens by the gasket, making sure not to touch or soil
either surface of the spread lens.
4 Place the spread lens on top of the ColorReach Powercore gen2 housing. Make
sure that the spread lens and gasket are seated properly within the fixture
housing. Also make sure that there is no moisture between the spread lens and
the glass, as any moisture will compromise the effectiveness of the spread lens.
ColorReach Compact Powercore
11
Product Guide
Advertisement
