Here are the steps to configure Band Steering from the WebUI:
Go to Wireless / Advanced Tab and enable the Band Steering Status button.
•
Set the RSSI Threshold values for 2.4GHz and 5GHz to the desired values (Valid
•
values are from -20 dBm to -90dBm, with a default value of -80 dBm. The values are
greyed out when the feature is disabled).
For the Band Steering feature to work, the Network Name should be same for both
•
2.4GHz and 5GHz primary SSIDs. User can configure the same in Wireless / Radio
Tab. The security parameters for the 2.4GHz and 5GHz for this network should also
be same. User can set the same in Wireless / Security Tab.
Note: Do not forget to hit the Save button after all changes are made.
7.3.2
SNMP provisioning for Advanced Wireless Setting
S. No.
MIBs
1
rdkbRgdot11nExtPhyRate
2
rdkbRgdot11ExtCtsProtectionE
nable
3
rdkbRgDot11ExtBeaconInterval
4
rdkbRgDot11ExtDTIMInterval
3/6/2018
Figure 7.7
Description
rdkbRgdot11nExtPhyRatesets
transmission rate.
rdkbRgdot11ExtCtsProtectionEnable
sets the CTS protection mode.
rdkbRgDot11ExtBeaconIntervalsets
the beacon interval.
rdkbRgDot11ExtDTIMIntervalsets the
DTIM interval.
Proprietary and Confidential - Technicolor
the
60