JessEm Tool Mast-R-Fence Operating Instructions And Parts Manual page 9

Slide the fence back to the center of the Slide the fence back to the center of the
table. Re-check to see if the fence is check to see if the fence is
centered on the table. If not repeat until centered on the table. If not repeat until
you achieve your desired result. achieve your desired result.
Installing the Sub-Fences
Locate the sub-fences in the
packaging. Place the sub-fence
against the front of the fence
extrusion (Fig. 14). Align the holes in extrusion (Fig. 14). Align the holes in
the sub-fence with the slots in the fence with the slots in the
fence extrusion. Insert the 6mm x extrusion. Insert the 6mm x
45mm screws through the hole in the mm screws through the hole in the
front of the sub-fences (Fig. 15). fences (Fig. 15).
Place the 6mm washer over the sub Place the 6mm washer over the sub-
fence bolt. Screw the black knob lt. Screw the black knob
onto the sub-fence bolt (Fig. 16). fence bolt (Fig. 16).
Repeat these steps for the remaining Repeat these steps for the remaining
two holes. Repeat these for the other two holes. Repeat these for the other
sub-fence.
Fences
fence
Figure 14 Figure 14
Figure 15
Figure 16
Figure 17