JessEm Tool Mast-R-Fence Operating Instructions And Parts Manual page 4

Tools Required for Assembly Tools Required for Assembly
 Phillips screw driver
 10 mm wrench or socket
10 mm wrench or socket
 3/16" Drill Bit*
 1/16" Drill Bit*
*Note: This is required if you are not mounting to a JessEm table top. *Note: This is required if you are not mounting to a Je
Assembling the Fence Tracks the Fence Tracks
There are two different types of fence There are two different types of fence
tracks depending upon which model tracks depending upon which model
fence you have purchased. fence you have purchased.
Fence model 04010 (Master Fence) Fence model 04010 (Master Fence)
has a table mounting bracket provided has a table mounting bracket provided
with a T-nut slot for mounting nut slot for mounting the
fence to the bracket (Fig 1). When
assembling the table mounting bracket assembling the table mounting bracket
to the fence track use a 6mm hex bolt to the fence track use a 6mm hex bolt
with a flat washer and insert the bolt with a flat washer and insert the bolt
into the lower slots on the fence track. into the lower slots on the fence track.
Screw the T-nuts onto the bolts. Slide nuts onto the bolts. Slide
the T-nuts into the T-slot on the table
mounting bracket. Do not tighten this mounting bracket. Do not tighten this
assembly at this stage.
Fence model 04100 (Router Fence) Fence model 04100 (Router Fence)
has a table mounting bracket but does has a table mounting bracket but does
not have the T-slot in the bracket as slot in the bracket as
Model 04010. Mount the table bracket Mount the table bracket
directly to the fence track using 6mm directly to the fence track using 6mm
hex bolts and flat washers (Fig. 2) and flat washers (Fig. 2). Do
not tighten this assembly at this stage. not tighten this assembly at this stage.
. When
slot on the table
Figure 1
Figure 2